5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

• use of a supertype entity does not make applicable any of its specializations, unless the specialization is also imported in the MIM schema;
• use of a SELECT type does not make applicable any of its listed types unless the listed type is also imported in the MIM schema.

Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined in Annex B.

USE FROM Geometric_tolerance_mim;    --  ISO/TS 10303-1051



USE FROM Part_shape_mim;    --  ISO/TS 10303-1807



USE FROM Product_and_manufacturing_information_with_nominal_3d_models_mim;    --  ISO/TS 10303-1811
(*



NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Geometric_tolerance_mim	ISO/TS 10303-1051
Part_shape_mim	ISO/TS 10303-1807
Product_and_manufacturing_information_with_nominal_3d_models_mim	ISO/TS 10303-1811

NOTE 2   See Annex D, Figures D.1and D.2 for a graphical representation of this schema.

5.2.1 MIM type definition

This subclause specifies the MIM type for this application module. The MIM type and definition is specified below.

5.2.1.1 mb3dgdtr_geometric_model_item   

The mb3dgdtr_geometric_model_item type is an extension of the geometric_model_item type. It adds the data types connected_face_set, and edge_loop to the list of alternate data types.

NOTE  The list of entity data types may be extended in application modules that use the constructs of this module.

EXPRESS specification:

*)
TYPE mb3dgdtr_geometric_model_item = EXTENSIBLE GENERIC_ENTITY SELECT BASED_ON geometric_model_item WITH
   (connected_face_set,
    edge_loop);
END_TYPE;
(*

© ISO 2018 — All rights reserved