Application module: Mechanical design geometric presentation ISO/TS 10303-1313:2008(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

Contents

1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 Information requirements
    4.1 Required AM ARMs
    4.2 ARM entity definitions
          4.2.1 Mechanical_design_view_area
          4.2.2 Mechanical_representation_styled_model
5 Module interpreted model
    5.1 Mapping specification
          5.1.1 Mechanical_design_view_area
          5.1.2 Mechanical_representation_styled_model
    5.2 MIM EXPRESS short listing
Annex A MIM short names
Annex B Information object registration
   B.1 Document identification
   B.2 Schema identification
Annex C ARM EXPRESS-G
Annex D MIM EXPRESS-G
Annex E Computer interpretable listings
Bibliography
Index

Figures

Figure C.1 — ARM schema level EXPRESS-G diagram 1 of 1
Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 1
Figure D.1 — MIM schema level EXPRESS-G diagram 1 of 1

Tables

Table E.1 — ARM and MIM EXPRESS listings


© ISO 2008 — All rights reserved