Application module: Default tolerance ISO/TS 10303-1052:2014-02(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definition
     5.2.2 MIM entity definitions
     5.2.3 MIM function definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Application module implementation and usage guide
G Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious page
Figure D.2 — MIM entity level EXPRESS-G diagram 1 of 1 ../default_tolerance/sys/5_mim.htm#default_tolerance_mim.dt_document_reference_item ../document_assignment/sys/5_mim.htm#document_assignment_mim.document_reference_item ../../resources/product_property_definition_schema/product_property_definition_schema.htm#product_property_definition_schema.property_definition ../../resources/representation_schema/representation_schema.htm#representation_schema.compound_representation_item ../../resources/representation_schema/representation_schema.htm#representation_schema.representation ../default_tolerance/sys/5_mim.htm#default_tolerance_mim.default_tolerance_table_cell ../default_tolerance/sys/5_mim.htm#default_tolerance_mim.default_tolerance_table


Figure D.2 — MIM entity level EXPRESS-G diagram 1 of 1


© ISO 2014 — All rights reserved