ISO 10303-113:2021(E)


Integrated application resource: Mechanical features	ISO 10303-113:2021(E) © ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
3.1 Terms and definitions
3.2 Abbreviated terms

4 Counterbore countersink
4.1 General
4.2 Fundamental concepts and assumptions
4.3 Counterbore countersink type definitions
4.4 Counterbore countersink entity definitions
4.5 Counterbore countersink subtype constraint definition
5 Machining feature
5.1 General
5.2 Fundamental concepts and assumptions
5.3 Machining feature type definition
5.4 Machining feature entity definitions
5.5 Machining feature subtype constraint definition
5.6 Machining feature rule definitions
6 Mechanical design
6.1 General
6.2 Fundamental concepts and assumptions
6.3 Mechanical design type definitions
6.4 Mechanical design entity definitions
6.5 Mechanical design function definitions
6.6 Mechanical design rule definitions

A Short names of entities
B Information object registration
C Computer interpretable listings
D EXPRESS-G diagrams
E Technical discussion
F Change history
Bibliography
Index

Annex F
(informative)

Change history

F.1 General

This annex documents the history of technical modifications made to ISO/TS 10303-113.

Unless otherwise specified all modifications are upwardly compatible to the previous edition. Modifications to EXPRESS specifications are upwardly compatible if:

instances encoded according to ISO 10303-21, and that conform to an ISO 10303 application protocol based on the previous edition of this document, also conform to a revision of that application protocol based on this edition of this document;
interfaces that conform to ISO 10303-22 and to an ISO 10303 application protocol based on the previous edition of this document, also conform to a revision of that application protocol based on this edition of this document;
the mapping tables of ISO 10303 application protocols based on the previous edition of this document remain valid in a revision of that application protocol based on this edition of this document.

F.2 Changes made in edition 2

F.2.1 Summary of changes

This second edition of this document incorporates the modifications to the first edition listed below.

F.2.2 Changes made to schema counterbore_countersink_schema

The following EXPRESS declarations and interface specifications have been modified:

ENTITY basic_round_hole
Where WR1 was corrected to reflect the intent.

F.2.3 Changes made to schema mechanical_design_schema