Application module: Machining features ISO/TS 10303-1814:2019(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM subtype constraint definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definition
     5.2.2 MIM entity definition
     5.2.3 MIM rule definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious pageNext pageLast page
Figure C.9 — ARM entity level EXPRESS-G diagram 8 of 19 ./armexpg20.htm ./armexpg19.htm ./armexpg2.htm ./armexpg6.htm ./armexpg20.htm ./armexpg18.htm ./armexpg18.htm ./armexpg6.htm ./armexpg20.htm ./armexpg20.htm ./armexpg20.htm ./armexpg20.htm ./armexpg18.htm ./armexpg2.htm ./armexpg20.htm ./armexpg4.htm ./armexpg6.htm ./armexpg3.htm ./armexpg4.htm ./armexpg4.htm ./armexpg4.htm ./armexpg3.htm ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../shape_property_assignment/sys/4_info_reqs.htm#shape_property_assignment_arm.shape_element ../machining_features/sys/4_info_reqs.htm#machining_features_arm.planar_face ../machining_features/sys/4_info_reqs.htm#machining_features_arm.protrusion ../machining_features/sys/4_info_reqs.htm#machining_features_arm.step ../machining_features/sys/4_info_reqs.htm#machining_features_arm.rounded_end ../machining_features/sys/4_info_reqs.htm#machining_features_arm.revolved_feature ../machining_features/sys/4_info_reqs.htm#machining_features_arm.spherical_cap ../machining_features/sys/4_info_reqs.htm#machining_features_arm.general_revolution ../machining_features/sys/4_info_reqs.htm#machining_features_arm.groove ../machining_features/sys/4_info_reqs.htm#machining_features_arm.revolved_flat ../machining_features/sys/4_info_reqs.htm#machining_features_arm.revolved_round


Figure C.9 — ARM entity level EXPRESS-G diagram 8 of 19


© ISO 2019 — All rights reserved