TYPE non_negative_length_measure

(* SCHEMA step_merged_ap_schema; *)

-- IN AP203e2/AP214/AP238 STEP-NC/AP242
TYPE non_negative_length_measure = length_measure;
   WHERE
      WR1:
         SELF >= 0.0;
END_TYPE;

Referenced By

Defintion non_negative_length_measure is references by the following definitions:
DefinitionType
 cdgc_with_dimension ENTITY
 extruded_face_solid_with_trim_conditions ENTITY
 measure_value SELECT
 pdgc_with_dimension ENTITY
 pgc_with_dimension ENTITY
 positive_length_measure REAL
 sdgc_with_dimension ENTITY
 skew_line_distance_geometric_constraint ENTITY
 solid_with_conical_bottom_round_hole ENTITY
 solid_with_flat_bottom_round_hole ENTITY
 solid_with_groove ENTITY
 solid_with_pocket ENTITY
 solid_with_rectangular_pocket ENTITY
 solid_with_rectangular_protrusion ENTITY
 solid_with_trapezoidal_section_slot ENTITY


[Top Level Definitions] [Exit]

Generated by STEP Tools® EXPRESS to HTML Converter
2025-09-04T17:14:52-04:00