TYPE non_negative_length_measure

(* SCHEMA Ap210_electronic_assembly_interconnect_and_packaging_design_mim_lf; *)

TYPE non_negative_length_measure = length_measure;
WHERE
	WR1 : SELF >= 0.0;
END_TYPE;

Referenced By

Defintion non_negative_length_measure is references by the following definitions:
DefinitionType
 extruded_face_solid_with_trim_conditions ENTITY
 measure_value SELECT
 positive_length_measure REAL
 solid_with_conical_bottom_round_hole ENTITY
 solid_with_flat_bottom_round_hole ENTITY
 solid_with_groove ENTITY
 solid_with_pocket ENTITY
 solid_with_rectangular_pocket ENTITY
 solid_with_rectangular_protrusion ENTITY
 solid_with_trapezoidal_section_slot ENTITY


[Top Level Definitions] [Exit]

Generated by STEP Tools® EXPRESS to HTML Converter
2012-03-27T17:15:30-04:00